|
Carbon
Steel HydrAcc: For or use in non-corrosive
fluid power hydraulic systems as a pressure compensator for leakage, a hydro
pneumatic spring for suspension systems and counterbalances in fork trucks,
combine harvesters, machine tool heads and marine applications, stand by
emergency shut-down power systems, for valve actuators and, general power
pack intermittent high flow rate energy conservation.
Carbon Steel & Nitrile/Buna N for Oil Hydraulic applications.
EP for Fire resist fluids, Viton for Hi temp systems.
More Information:
Part Numbers / Sizing
|
Small |
| HAcc-15i-B57x98-4500p-1/2"NPT-CS |
| HAcc-40i-B62x207-2500p-3/4"NPT-CS |
| HAcc-75i-B72x315-2500p-1 1/2"NPT-CS |
|
Medium |
| HAcc-170i-B123x250-2300p-1 1/2"NPT-CS |
| HAcc-200i-B123x295-2300p-2"NPT-CS |
| HAcc-240i-B139x205-2500p-2"NPT-CS |
|
Large |
| HAcc-488i-B139x420-2500p-3"NPT-CS |
| HAcc-693i-B195x360-3500p-4"NPT-CS |
| HAcc-1220i-B230x500-3500p-4"NPT-CS |
Information About: Part
Numbers / Sizing
- The prefix "HAcc" inserted where "HydrAcc" is located
denotes this design: i.e. gas inside one-piece molded bag.
- The number following the prefix that is followed
by the letter "i" denotes the number of cubic inches nominal volume.
Units of 16.39millilitres, there are 61 cubic inches in one liter.
- The B reference is the diameter followed by length
of the one piece molded bag. This is also the spare part reference for
a new bag / bladder.
- The number preceding the letter p is the design pressure,
this should be used for working pressures up to 85% of the p figure
assuming that the system relief valve requires a 15% over pressure to
fully open.
- The inch number denotes National Pipe Thread taper
size.
- A letter needs inserting following the 316. The letter
replaces ?? and denotes the elastomer of the membrane to be used ex/e.g.
N = Buna-N / Nitrile, V = Viton, etc.
See also:
HydroTrole Limited Bladder Type Accumulators
Main Page
|
