|
Plastic HydrAcc
accumulators are popularly from PVC or from polypropylene for the accumulation
of water purification industry specialty fluids with difficult materials
compatibilities.
Plastic housings with Hypalon & other elastomers for
Ferric Chloride and Hydrochloric Acid resistance.
More Information:
Part Numbers / Sizing
|
Small |
| HAcc-PLAS-6i-B44x75-300p-1/2"NPT-?? |
| HAcc-PLAS-15i-B57x98-250p-3/4"NPT-?? |
| HAcc-PLAS-30i-B57x173-150p-1"NPT-?? |
|
Medium |
| HAcc-PLAS-60i-B63x214-125p-1"NPT-?? |
| HAcc-PLAS-90i-B98x232-110p-1 1/4"NPT-?? |
| HAcc-PLAS-180i-B139x178-100p-1
1/2"NPT-?? |
|
Large |
| HAcc-PLAS-356i-B139x325-100p-2"NPT-?? |
| HAcc-PLAS-488i-B139x420-100p-2"NPT-?? |
| HAcc-PLAS-1220i-B230x500-85p-3"NPT-?? |
Information About: Part
Numbers / Sizing
- The prefix "HAcc" inserted where "HydrAcc" is located
denotes this design: i.e. gas inside one-piece molded bag.
- The number following the prefix that is followed
by the letter "i" denotes the number of cubic inches nominal volume.
Units of 16.39millilitres, there are 61 cubic inches in one liter.
- The B reference is the diameter followed by length
of the one piece molded bag. This is also the spare part reference for
a new bag / bladder.
- The number preceding the letter p is the design pressure,
this should be used for working pressures up to 85% of the p figure
assuming that the system relief valve requires a 15% over pressure to
fully open.
- The inch number denotes National Pipe Thread taper
size.
- A letter needs inserting following the 316. The letter
replaces ?? and denotes the elastomer of the membrane to be used ex/e.g.
N = Buna-N / Nitrile, V = Viton, etc.
See also:
HydroTrole Limited Bladder Type Accumulators
Main Page
|
