|
X-ray Spectography of Metals "PMI"
Positive material identification by X-Ray fluorescence.
Identifying Metal with Eddy Current Using the ED250
Identifying Metal with Eddy Current Using the ED250.
Instructions for Hardness Testing Steel
This inspection is for the hardness testing (H.T.) within
the parameters of the ROCKWELL "C" SCALE.
Instructions for Ultrasonic Thickness Testing: Thin, Flat
or Round Surfaces
This Work Instruction is with the ultrasonic thickness
tester "TM1D" which is only accurate in a thickness range from about .5
mm to 8 mm due to the frequency and size of the transducer,
and is accurate on a curved surface down to around 3.5 mm Rad.
Instructions for Calibration of Inspection and Test Equipment
Hydro-pressure, gas pressure gauges, torque wrenches,
dial indicators, and micrometers.
Inspection and Testing
This procedure describes the stages at which inspections
and tests of the product are carried out to ensure its conformance to the
application purpose specification.
Crack Detection by Eddy Current
Instructions for eddy current inspection of ShockGuards.
Pre P.E.D. and EN 13445 Safety Design and Use Code
Hydro-pneumatic Accumulator / Damper Safety Design
and Use Code
Offshore Equipment - North Sea
An image of offshore locations where we have or have had equipment in
use, in the North Sea.
Offshore
Production Platform
An image of some components included on an offshore production platform.
Offshore Drilling Rig
An image of some components included on an offshore drilling rig.
|
